Hoefer SE215 User Manual download pdf (Page 16)

•

p14

5. Troubleshooting

problem solution

Plates broken Stack may be too tall. Before clamping, check that

the stack is about 1 mm higher than the top of the

caster edge.

Check that all spacers and plates are aligned before

applying the clamps.

Notched plate ears broken Avoid stressing the ears by only handling the sand-

wiches by the sides and bottom.

Separate sandwiches along the bottom of the stack.

Caster leaks Apply a light ﬁlm of Gel seal to the gasket each time

the unit is used.

Check the foam gasket for cracks or nicks and replace

if necessary.

If the stack is too tall, the front plate may not seat

ﬁrmly against the gasket. Remove ﬁller plates until

the stack seals.

Gel heights uneven Pour the monomer solution into only one sandwich

and allow the groove in the triangular plug to evenly

distribute the solution.

Make sure the groove in the triangular plug is clean

and clear of material.

Wait one minute before overlaying each gel so that

the solution “settles”. Then add the same amount of

overlay solution to each sandwich.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

No comments

Hoefer SE215 User Manual Page 16